Cart 0

Expert's Corner — dowel

TIP: Avoiding glue squeeze-out in joints

bond chamfer dowel glue the finishing store wood woodfinishing woodwork woodworking

TIP: Avoiding glue squeeze-out in joints

The obvious cause of glue squeeze-out in joints is that too much glue has been applied. So the obvious way to avoid the squeeze-out and resulting splotching under a stain or finish is to apply less glue. As shown in the accompanying picture, you can countersink a mortise and a dowel hole to create a reservoir for excess glue to collect. You can also chamfer the ends of tenons and dowels. Most dowels are manufactured with the ends already chamfered.But you don’t want to apply too little glue either or you won’t get a good bond. So here’s a trick...

Read more →